DUAL OSCILLATOR 46 A

The Dual Oscillator 46A module is two wide range temperature compensated VCOs in a single space. The 46A uses the same stable VCO core from the Oscillator 01A. Designed to offer the fattened sound of two oscillators with the added convenience of global tuning and switch selectable octave range controls. The UI is optimized for standard keyboard controller use. Referenced tuning controls simplify setup when performing with other concert pitch instruments.

Features:

• 2 VCOs with switch select saw and sqr/pulse wave forms
• Global tracking of both osc. with one volt per octave input
• Mix out with cross fade level control
• Auxiliary VCO ' B ' output for independent processing
• Initial Pulse Width control and CV PWM destination control
• Individual CV modulation inputs with attenuators for A/B
• Detune control offsets pitch for added animation.
• Global Fine tune control
• Calibrated 6 position Rotary Octave range switch
• Calibrated 3 position octave offset* switch for 'B' Oscillator
• Front panel access to scaling calibration trim pots

  *larger offset intervals are possible using the CV inputs.

  Demo in low res 64kbps MP3 format at 22Khz
  Switched on Modcan
  This demo was recorded in 2 passes for the left and right hand. Also features the 904A 44A Moog LPF clone

   

  Specifications:
  Inputs: 100K ohms
  Outputs: 1K ohms
  Signal Output: Saw and Pulse: 0-5V
  Switch Range 16.3Hz-523.3Hz in Octaves
  18-20 Octaves available using 1V/Oct and CV inputs combined
  B Octave Offset Toggle switch: 2 Octave Range
  Detune Range +/- 1 Octave
  Control sens: 1V/Oct